Just got my bongo amd a cheap mod which would be useful is to replace the ashtray with a cup holder. I know MX-5 fits but they seem pricey at £40, and have seen 3d printed on ebay for 14.
Anyone got one got one surplus to requirement, ot any exeprience of either the mx-5 replacement or ebay 3d printed??
Cup holder to replace ashtray
Moderator: francophile1947
- BongoBeeman
- Junior Bongonaut
- Posts: 25
- Joined: Sun Jun 14, 2015 9:46 pm
- Location: Bristol
Re: Cup holder to replace ashtray
These flasks are good and fit in the existing cup holders.
Keep your drinks warm for a good while.
https://www.alloutdoor.co.uk/equipment/ ... 21EALw_wcB
Other outdoors shops and Amazon do them.
Keep your drinks warm for a good while.
https://www.alloutdoor.co.uk/equipment/ ... 21EALw_wcB
Other outdoors shops and Amazon do them.
- BongoBeeman
- Junior Bongonaut
- Posts: 25
- Joined: Sun Jun 14, 2015 9:46 pm
- Location: Bristol
Re: Cup holder to replace ashtray
Ah, nice, thank youBob wrote: ↑Mon Jan 27, 2020 2:29 pm These flasks are good and fit in the existing cup holders.
Keep your drinks warm for a good while.
https://www.alloutdoor.co.uk/equipment/ ... 21EALw_wcB
Other outdoors shops and Amazon do them.
Re: Cup holder to replace ashtray
You're most welcome.
If you cycle they fit the bottle cage on your bike, too.
Just make sure you leave about 1/2" space below the screw thread when you fill them, and don't be tempted to fill with boiling water and shake. The top will blow off.
If you cycle they fit the bottle cage on your bike, too.
Just make sure you leave about 1/2" space below the screw thread when you fill them, and don't be tempted to fill with boiling water and shake. The top will blow off.