I've just had some seat pads made to go on my existing rock n roll bed, but there's no obvious way of securing them to the frame. The manufacturer just said screw them on, but a) the backing is hardboard so screws will not take long to rip out b) the shaper end of the screws will eventually rip through the other side of the foam and make life uncomfortable. Has anyone got any experience of fitting such seats?
Cheers
Ed
Fitting new seat pads to an existing RnR bed
Moderator: Doone
Re: Fitting new seat pads to an existing RnR bed
Could you glue on some Velcro?
- g8dhe
- Supreme Being
- Posts: 10180
- Joined: Sun Apr 13, 2008 10:06 pm
- Location: Worthing, West Sussex.
- Contact:
Re: Fitting new seat pads to an existing RnR bed
Mine just rest on the plywood board for the seats and the back part is made with "straps" over the top so that it just rests in position over the raised back sections. When its all flat then the they all butt together to make the matteress.
Re: Fitting new seat pads to an existing RnR bed
Thaks for the idea, I need them to stay on quite solidly as the dogs sit on the seat while travelling, so velcro is a better solution for me on this occasion.