Hi Everyone, I am a new bongo owner and am starting a rear conversion as I need to retain at least 6 seater functionality.
I've done a bit of searching on site and I can't find an answer to this one.
Does anyone have any recommendations for the location of the commando socket for an electrical hook up.
Once the socket is in place, how do you/would you run the cable through the van to get to the rear (if the socket is not there).
Thanks in advance.
Hook up socket location and cable run.
Moderator: Doone
-
- Bongonaut
- Posts: 56
- Joined: Fri Jul 21, 2017 4:26 pm
-
- Bongonaut
- Posts: 56
- Joined: Fri Jul 21, 2017 4:26 pm
Re: Hook up socket location and cable run.
Hey guys, anyone got any thoughts about this?
- the1andonly
- Tribal Elder
- Posts: 772
- Joined: Sat Nov 10, 2012 8:17 pm
- Location: Northampton
Re: Hook up socket location and cable run.
Try this thread
pity about dead pickies
my twopennarth worth is on page 2
http://igmaynard.co.uk/bongo/forum/view ... hilit=hook
pity about dead pickies
my twopennarth worth is on page 2
http://igmaynard.co.uk/bongo/forum/view ... hilit=hook
Re: Hook up socket location and cable run.
Good post, it's pretty well down to where it's sensible to put it.
Once the panels are off for the conversion have a look for a good spot.
Hope that helps a litle, or try a lead like this for a while:
https://www.blacks.co.uk/equipment/0230 ... w.ds#close
Once the panels are off for the conversion have a look for a good spot.
Hope that helps a litle, or try a lead like this for a while:
https://www.blacks.co.uk/equipment/0230 ... w.ds#close
Re: Hook up socket location and cable run.
Rather than chopping a hole in the bodywork I intend to fit mine alongside the trailer socket.
Waterproofed obviously
Waterproofed obviously
Re: Hook up socket location and cable run.
Just had my EHU socket fitted underneath as part of a rear conversion. It's fitted to the towbar, directly behind the offside rear fog lamp. 'Maypole' produce a socket complete with a cap, ideal for this type of installation; the part number is MP594B.
Mark
1999 Bongo 2.0L, Northstar Outback rear conversion
1999 Bongo 2.0L, Northstar Outback rear conversion
Re: Hook up socket location and cable run.
Nice one. I shall be Googling that.Markas wrote:Just had my EHU socket fitted underneath as part of a rear conversion. It's fitted to the towbar, directly behind the offside rear fog lamp. 'Maypole' produce a socket complete with a cap, ideal for this type of installation; the part number is MP594B.