Did you mean non specific Bongo switches....? If so, this may help..? http://www.igmaynard.co.uk/bongo/forum/ ... dow+switch

If ever you find the tail/side/dash fuse popping for no apparent reason? Check the contacts in the bulb holder.. They are flimsy & if a new bulb has been fitted they could crush & short it out..?

1, the os electric blinds. The switch front switch sometimes works. Sometimes doesn't. Usually starts to work when I go over a bump. Any common place for a loose connection? 2, the rear ac only blows hot. Even on cold. No difference in temperature. Any suggestion? 3, the side door. I think I should...

Hi Dave, Sorry to hear about yer trouble.. The fans should cut in with the AC on.. However there is a pressure sensor for the refrigerant... Part 61-503 http://lushprojects.com/bongopartsmk2/code=6130A&cat=a2ajra05&vin=&imgno=01of02.html#22 If the refrigerant is too low the fans wont cut...

I concur with Ady... But if the compressor pump has seized? I would also unplug the single wire connector going to it to stop the magnetic clutch engaging...

... Having said that the belt may have snapped so no real need..!

flossie wrote:IAlso I have to check why the fans arent cooling the engine properly.

Do you mean when you switch the AC on..? I think if there is no or V little gas in the system the fans wont operate??

There is a pressure sensor switch in the top of the jar by the condenser..?

Hi many thanks for your replies! Are they an easy DIY job to change? Obviously will need a vac regas and oil cheers I'm no real "spanner man"... More into auto electrics really.. Just bought a used compressor pump from a guy recommended by Simon Jones, some seals & belts from the BF s...

Hi Rob, I'm gonna stick my neck out & say it's the same compressor pump as the diesel....? Though I've only ever fitted one to a diesel. Best to make sure though..!!! A quick test to make sure the second hand replacement works (not seized as well?) when you get one before bolting & plumbing ...

I managed to remove to front half of the under belly pan to gain access to mine. (But i was replacing the AC compressor pump at the time too.) I thought what the hey! 3 new belts while i'm at it... http://lushprojects.com/bongopartsmk2/code=1580C&cat=a2ajra05&vin=&imgno=.html Assuming yo...

Jockey wheel bearings??

The "re-inforcement" is just the original loom cover/tidy cut down to half where it split/perished on the hinge clip, along with a few of the wires underneath.... .. I got my mirrors to fold on locking too. But lucky i didn't have to put any loom for the module through the door for that on...

Probably easier to find & repair the break than run new right through to the switch..? The V bend causes more long term problems than it solves in my opinion.. Here is what i did to mine after a repair & running some extra loom in for the remote CL & window closure mod on locking... http...

well drivers side switch u/s apart from isolating passenger side. I think it could be a broken wire as there is no 12V at any position on the wires; on the drivers side what colour wire should be bringing 12V up?? I would hazard a guess you have a broken wire in the door loom between the door &...

ProfDave wrote: In the same vein; I am guessing that there are relay for the electric windows up and down; where are these too!

thanks!!

Dave

There doesn't seem to be a relay for the power windows.....!





What is your window problem??

I managed to get a bulb from my local Mazda place.

Mazda part number H26066461 for anyone wanting to contact a Mazzy dealer...