Thanks Geoff,

Great help could not find the break in the loom so will gets some of that size cable and thread it through.

Thanks Bob,

That does sound a lot easier, will do that tomorrow.

Hello all, I am looking for the correct cable size for the electric window on the drivers side for the 30 Amp fuse. I need to supply the 12 Volts to the switch as it is broken somewhere. Does anybody know the correct AWG for it. I have looked around and thought 16 AWG for a 2 metre run would be ok t...

Thanks for that, I have some time off on Thursday so will go knocking a few doors etc

Hi all,
I have got the sprinter arches as suggested and in the cardiff area. Just looking for somebody now to do the work. Cut them out and replace etc.
Anybody got any good recommendations and also roughly how much should I be looking at for both arches.

Thanks

Thanks for the VIN info all these abbreviations I need a lie down

The KYB ones are £67.80 and only get charged £6 for the pair to be delivered. http://www.buypartsby.co.uk/buy/MAZDA/BONGO/_FRIENDEE/2.5/1995/__/101/steering-suspension/shock-absorbers/kyb-shock-absorbers/ Sorry the link did not work. Also nickie you mentioned you got them from a mazda main dealer I ...

Hello all, I have just been informed that the drivers side shock absorber needs to be replaced so they recommended doing both as one would be stronger than the other. So i have manged to find the following website with the parts on h[url]ttp://www.buypartsby.co.uk/buy/MAZDA/BONGO/_FRIENDEE/2.5/1995/...

Thanks for the info regarding the blockage I will look into that.

Hello all, Just been watching the Bongo being bleed on youtube and although I have asked the garage before to change coolant etc after hose pipe had split. I am not sure they would have gone to this amount of trouble to ensure that the air in the system had been removed. Is there anybody in the Card...

Hi, thanks for all your advice. Our bongo runs with straight diesel (from Tesco does it matter?). The Glow plugs were said to be fine as the car starts ok and that these would only be an issue if the bongo struggled to start via the key. I am no expert so I don;t know how they tested it. I think tha...

Thanks for that

Just a quick question where is the banjo filter located, what does it look like and can i just clean it easily.

Thanks

Thanks for the info, once the car is warmed up it is fine. I will have a look at the banjo filter and look to see if pipes are perished around vacum solenoids. If it's happening when cold & ok when warm it would point towards the cold start vacuum solenoids to me, either broken or pipes perished...

Thanks for the info, I will look into these.