sotal - look - photo and size https://www.buycarparts.co.uk/abs-sensor/m-facet

may be look "universal ABS sensor" from ERA 560052- it long 24.5 mm https://cardone.org/market/catalog/Regu ... ERA-560052

0K31L4373XD = ERA 560172 http://www.port3.ru/info/ERA/560172

0K31L4373XD - it is photo
high - 19mm resistans - 1.4 kOm

Izzy Bongo - delete termostat and open cap of cooling tank - if you bongo dont need more water and dont have more vapour from exahaust - you may carefully use it bus/////I use my bongo apr 2500 km during 3 month when wait new head////

if it possible - do "pressure test" again https://youtu.be/jWakwJCO7NI

NOTE! on "new chines head" be leak valves, be wery bad "valves sealer" - you must decide it befor install it!!!

I hard translate-sorry/// I talk about - new head have t-piece - it is for non-turbo engine, you need use 4-piece tube

look that https://mikrob.ru/download/file.php?id=336925&t=1 https://mikrob.ru/download/file.php?id=336923&t=1 https://mikrob.ru/download/file.php?id=336927&t=1 https://mikrob.ru/download/file.php?id=336929&t=1 and NOTE- on "chines head" you must use "old pimp" fro...

"where did you get these figures from as the ranger manual I have says 29nm then 90deg. and then another 90deg" - I turn bolt and look what crushd before - my old head, my old block or bolt.....and ask any people - check torque too....it dont "techinfo" from manual book - it only...

on diesel 14- after turning the corner -check torque moment - "thin" apr 90 Nm, "fat" -apr 130 Nm

created a vacuum-check cap of fuel tank

please - say me what that "40 quid"? on my bongo "compression pressure" apr 29-31 kgs\sm2 (apr 30 bar)
and - you may finde only two "repair size" of pistons and ring +0.25, +0.5mm......but it is "chines aftermarket parts" - it must check carefully!

NOTE! after "cut face of block" for flate - you must in all cause check and cut "head of piston" - on bongo use only one thickness (apr 1.1-1.15mm) of heads gasket and valves dont "state at flate of heads face" - valves protrude of head apr 0.7-1.0mm .....our piston mus...

at what place of block you want "skimmed"?