Air-Lift Suspension - Valve Location

[JoeC]

Not after how good / bad these are but after ideas of where and how to mount the valves that you input the air in via.
Pictures and idea would be gratefully appreciated.

Thanks
Joe

[g8dhe]

Mine are mounted on the rear panel of the tool cupboard under the step, keeps them nice and clean and protected, I don't find I need to get to them that often so its not a problem to remove the cover for access. Others have put them on the rear vertical section of the plastic step itself.

[Katka]

I put one valve on each side just behind the mudflap. Minimal pipe run and easy to get at - hasn't yet got too dirty or damaged.

[Propnut]

Mine are located on the vertical rearmost face of the plastic panel that forms the side door step. I was initially concerned that they could get kicked entering and leaving but as the door doesn't go back that far they've been fine. As I do a bit of towing it's good that they're nice and convenient too.

Previous thread on a similar topic here:- http://igmaynard.co.uk/bongo/forum/view ... ut#p678056

[JoeC]

Mine are mounted on the rear panel of the tool cupboard under the step, keeps them nice and clean and protected, I don't find I need to get to them that often so its not a problem to remove the cover for access. Others have put them on the rear vertical section of the plastic step itself.

Did you drill through the single skin metal towards the bottom of the tool cover hole?

[g8dhe]

Drilled thru the back panel itself, the valves face the cover up the far right hand end.

[JoeC]

Drilled thru the back panel itself, the valves face the cover up the far right hand end.

Thanks.